Hitachi 51F520 important safety instructions Rear Panel Jacks, Monitor OUT

REAR PANEL JACKS

ANT A

To

Converter

HDMI 1

FIRST TIME

		ANT B		INPUT 2	INPUT 1
				Y/	Y/
￿	MONITOR OUT	INPUT 4	INPUT 3	VIDEO	VIDEO
	S-VIDEO
				PB	PB
				PR	PR
	VIDEO
		(MONO)	(MONO)	(MONO)	(MONO)
	L
	AUDIO
	R
	AUDIO
	TO HI-FI

RS232C

1 2 3 4 5

6 7 8 9

USE

Antenna Input/Output

The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a sub-picture.) The antenna output labeled “TO CONVERTER” allows the ANT A connection to pass directly to a different source such as a cable box, only when ANT B is displayed as a main picture.

Audio/Video Inputs 1, 2, 3 and 4

By using the INPUTS button, CURSOR, and SELECT buttons of the remote control you can select each video source. Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert the audio cable into the left audio jack.)

NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a time.

￿MONITOR OUT

These jacks provide fixed or variable audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video output (see page 64).

S-VIDEO Inputs 3 and 4

Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

Component: Y-PBPRInputs

Inputs 1 and 2 provide Y-PBPRjacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may use composite video signal for both inputs.

NOTES: 1. Do not connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-VIDEO has priority over VIDEO input.

2.Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV’s PB input and the components R-Y output to the TV’s PR input.

3.Your component outputs may be labeled Y-CBCR. In this case, connect the component CB output to the TV’s PB

inputand the component CR output to the TV’s PR input.

4.It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PBPRinputs (see page 37).

5.To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-PBPRjacks.

6.Input 1 and Input 2 (Y/VIDEO) can be used for composite video and component video input.

9