The Remote Control for Cable Box Functions
The Remote Control
OPERATING THE PRECODED
FUNCTION FOR YOUR CABLE BOX.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of your cable box (refer below for
1.Turn ON your cable box.
2.Aim the remote control at the front of your cable box.
3.To switch to Cable (CBL)
4.Hold down the CBL button on the remote and enter the two digit preset code that matches your cable box, as shown below. Release the CBL button.
5.Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different two digit preset code.
6.The remote will now control your Cable box.
NOTE: 1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.
2.In the unlikely event that your cable box cannot be operated after performing the above procedures, please consult your cable box operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
CABLE (CBL) button
This button allows the remote to control your cable box by setting it to CABLE mode.
PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
CABLE BRAND | CODES |
HAMLIN | 22, 23, 24, 25 |
JERROLD | 00, 01, 02, 03, 04, 05, 06, 07 |
OAK | 26, 27, 28 |
PANASONIC | 18, 19, 20 |
PIONEER | 13, 14 |
SCIENTIFIC ATLANTA | 08, 09, 10 |
TOCOM | 15, 16 |
ZENITH | 11, 12 |
MY CABLE BOX CODE IS: _______________________
NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.
26
