Channel Manager
Channel Manager
Select CHANNEL MANAGER to set your Antenna options, run Auto Channel Scan, Check Signal Meter and Set Channel List.
1. | Press CURSOR PAD , or CHANNEL WHEEL to |
| highlight function |
2. | Press the SELECT button or CURSOR PAD to |
| select. |
Signal Meter
Select SIGNAL METER when using an indoor or outdoor antenna. This feature will show the signal strength and peak values of the Antenna signal to help you adjust your antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and Digital channels in Auto Channel Scan memory.
1. | Use the CURSOR PAD | or | or CHANNEL WHEEL |
| to highlight CABLE or AIR. |
| |
2. | Press the CURSOR PAD | or | to highlight the |
| START or CLEAR option. |
|
|
3.Press the SELECT button to start AUTO CHANNEL SCAN.
NOTE: 1. When a CableCARD is installed, Auto Channel Scan will not be available since channels will be fixed based on what was agreed upon by you and your cable operator.
2.If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2) by using the CURSOR buttons or .
Video
Audio
Channel Manager
Locks
Timers
Setup
Power Swivel
Move SEL Select
| Channel Manager | |
| Signal Meter | |
or | Auto Channel Scan | |
| Channel List | |
| Move | SEL Select |
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move SEL Select
| Channel Manager |
| |
| Signal Meter |
| |
or | Channel |
| 3- |
|
| ||
| Strength |
| 1 |
| Peak |
| 1 |
|
|
| Close |
| Move | SEL | Return |
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move SEL Select
Channel Manager
Auto Channel Scan
or | Cable |
|
| Auto Channel Scan | Start Reset |
| Cable Source | Cable(1) |
Air
Auto Channel Scan Start Reset
Move SEL Return
46
