Hitachi 42HDS52A, 55HDS52 important safety instructions Accessories, For U.S. models

Accessories

Check to make sure you have the following accessories before disposing of the packing material.

First time use

Remote Control	Two “AA” size,	Table Top Stand
	1.5V batteries	(42” models only)

Power Cord Cleaning Cloth

2 IR Mouse Cable	Power Swivel Cable
	(42” models only)

1 Ferrite Core (see page 13)

Note: Please visit our website for optional accessories for the 55” models.

For U.S. models:

For optional accessories, please access our web site at:

www.hitachi.us/tv

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical.

2.This stand for use only with Hitachi 42HDS52 and 42HDS52A. Use with other apparatus is capable of resulting in instability causing possible injury. See important marking located on bottom of stand.

Remote Control Unit CLU-3852WL	Table Top Stand (P# QJ01831K).
(Part No. HL02066).	Cleaning Cloth (P# MS00931).
Two “AA” size, 1.5V batteries (P# FQ00021).	Power Swivel Cable (P# EW08431).
Power Cord (P# EV01841).	Ferrite Core (P# 2169513).
Two IR Mouse cables (P# EY01641).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1.Open the battery cover of the remote control by pushing down and sliding the back cover off.

2.Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the springs and lift them out.

3.Match the batteries to the (+) and (-) marks in the battery compartment.

4.Replace the cover.

BOTTOM VIEW (Remote Control)

Press down and slide back to remove.

CAUTION: Do not insert batteries with ‘+’ and ‘-’ polarities reversed as this may cause the batteries to swell or rupture resulting in leakage.

4