The Remote Control for Cable Box Functions
Remote Control
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of your cable box (refer to
pages
1.Turn ON your cable box.
2.Aim the remote control at the front of your cable box.
3.To switch to Cable (CBL)
SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.
4. | Hold down the ENT button on the remote and enter |
| the four digit preset code that matches your cable |
| box as shown on pages |
| button. The indicator light will flash 3 times if the |
| code was accepted. |
5. | Aim the remote at the cable box and press the |
+
-
The
POWER button. The remote will turn off your cable |
box when the correct four digit preset code is |
entered. When this occurs, the remote control is |
programmed for your cable box. If the cable box |
does not turn off, try a different four digit preset |
code. |
6. The remote will now control your Cable box. |
NOTE: 1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.
2.In the unlikely event that your cable box cannot be operated after performing the above procedures, please consult your cable box operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
/
MY CABLE BOX CODE IS:
NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.
36
