Hitachi 55HDT79 Remote Control for Additional Audio Equipment, MY Audio Component Code is

The Remote Control for Additional Audio Equipment

Remote Control

Operating the precoded function for your Audio component.

This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system of your Audio component

(refer to pages 42-43 for pre-codes).

1.Turn ON your Audio component you wish to control with the Remote.

2.Aim the remote control at the front of your Audio component.

3.To switch to Audio (AMP) component pre-coded

mode, use the SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4. Hold down the ENT button on the remote and enter

the four digit preset code that matches your Audio

component, as shown on pages 42-43. Release

the ENT button. The indicator light will flash 3

times if the code was accepted.

￿

￿

+

-

￿

￿

￿

￿

The

5.	Aim the remote at the Audio component and press
	the POWER button. The remote will turn off your
	Audio component when the correct four digit
	preset code is entered. When this occurs, the
	remote control is programmed for your Audio
	component. If the Audio component does not turn
	off, try a different four digit preset code.
6.	The remote will now control your Audio
	component.
7.	Repeat steps 1 - 6 if you wish to program the
	remote to control another Audio component.

NOTE: 1. If your Audio component cannot be operated after performing the above procedures, your Audio component code has not been precoded into the remote.

2.	In the unlikely event that your Audio
	component cannot be operated after
	performing the above procedures, please
	consult your Audio component operating
	guide.
3.	The remote control will remember the

/

MY AUDIO COMPONENT CODE IS:

￿

￿

codes you have programmed until the

batteries are removed from the

remote control. After replacing the

batteries repeat the entire programming

procedure as stated above.

￿ PRECODED AUDIO Buttons

These buttons transmit the chosen precoded Audio

component codes.

￿ EXCLUSIVE TV Buttons

These buttons are for operating the TV.

NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.

40