VIDEO
Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.
2.Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode. DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.
Using the Remote Control, select
To Move Adjustment Point
To move the adjustment point cursor using the THUMBSTICK, the Adjustment Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white.
| Video |
|
| Audio |
|
| Ch. Manager | |
| Locks |
|
| Setup |
|
MENU | Move SEL | Sel |
|
| |
Video
Magic Focus
Aligns the Red, Green, and Blue colors to correct for Magnetic Influences.
Adjustment Mode
Auto | At Turn Off |
Manual | (After 90 days) |
If you want to adjust now 
Start
THUMB | THUMB |
STICK | STICK |
SELECT |
|
THUMB
STICK
SELECT
THUMB | THUMB |
STICK | STICK |
| SELECT |
Video |
|
Picture Mode | Sports |
Contrast | 100% |
Brightness | 50% |
Color | 50% |
Tint |
|
Sharpness | 50% |
Vertical Position |
|
Magic Focus |
|
Color System |
|
Advanced Settings |
|
Move SEL Select |
|
| Adjustment Point |
| Cursor |
Move SEL Return
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
DONE | : [1] | |
CANCEL | : [2] | |
EXIT |
|
|
INI. RESET : | [3] | |
BACK | : | [4] |
Press the [1] button on the remote control to SAVE adjusted data and return to main picture. Press the [2] button on the remote control to CANCEL adjusted data and return to main picture. Press the [3] button on the remote control to recall the factory
Press the [4] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [9] button on the remote control to read the SAVED adjusted data. If there is no saved data, pressing the [9] button will recall the factory
48
