How to Install the Washing Machine

Connecting the water supply

●●Water supply hose

■■Optimum water pressure is 0.03-0.8MPa.

■■Do not connect to the mixer tap of an unpressurised hot-water apparatus.

■■Use a horizontal tap.

Horizontal tap

Extension tap

Square tap

Connect the water supply hose to the rear panel of the washing machine.

Make sure that the rubber seal is inside the hose connector.

Hose connector

Rubber seal

* Model with SCREW TYPE water supply hose.

Firmly connect the water supply hose to the tap, and check connection points for water-tightness.

min. 10 mm

* Model with ONE TOUCH JOINT water supply hose.

1.Untighten the upper connector screw.

Upper connector

Rubber packing

Fixing screw

Middle

 

connector

●●In case the diameter of the tap is large, remove the guide plate.

Guide plate

Connector

2.Push the upper connector up till the rubber packing is in tight contact with the tap. Then tighten the 4 screws.

Rubber packing Upper connector

Middle connector

●●Turn the middle connector so that there is no water leak.

3. Connect the water supply hose to the middle connector, pushing the plate down.

Middle connector

Water supply hose

26

●●To separate the water supply hose from the middle connector, turn off the tap, and then pull the inlet hose down, pushing the plate down.

3WPL090501

Page 26
Image 26
Hitachi BD-W85TAE installation instructions Connecting the water supply, Water supply hose