BEVEL RIPPING
This cut is the same as ripping except the blade bevel angle is set to an angle other than 0º
RIPPING SMALL PIECES
To avoid injury from the blade contact, never make cuts narrower than 1/2 in wide.
1.It is unsafe to rip small pieces. Instead, rip a larger piece to obtain the size of the desired piece.
2.When a small width is to be ripped and your hand cannot safely pass between the blade and the rip fence, use one or more push sticks to move the workpiece. Always use a push stick during ripping operations.
CROSSCUTTING (FIG. CC)
To prevent serious injury:
•Do not allow familiarity or frequent use of your table saw to cause careless mistakes. Remember that even a careless fraction of a second is enough to cause a severe injury.
•Keep both hands away from the blade and the path of the blade.
•Never attempt to pull the workpiece backwards during a cutting operation. This will cause kickback and serious injury to the user can occur.
English
Fig. CC
1
32
USING WOOD FACING ON THE MITER GAUGE (Fig. DD)
Slots are provided in the miter gauge for attaching an auxiliary facing (1) to make it easier to cut very long or short pieces. Select a suitable piece of smooth wood, drill two holes through it and attach it to the miter gauge with screws. Make sure the facing does not interfere with the proper operation of the sawblade guard. When cutting long workpieces, you can make a simple outfeed support by clamping a piece of plywood to a sawhorse.
Fig. DD
1
BEVEL CROSSCUTTING (FIG. EE)
This cutting operation is the same as crosscutting except the blade is at bevel angle other than 0°.
1.Remove the rip fence and place the miter gauge in a miter gauge groove on the table.
2.Adjust the blade height so it is 1/8 in. higher than the top of the workpiece.
3.Hold the workpiece fi rmly against the miter gauge with the blade path in line with the desired cut location. Move the workpiece to 1in. distance from the blade.
4.Start the saw and wait for the blade (1) to come up to full speed. Never stand directly inline of the saw blade path, always stand to the side of the blade that you are cutting on.
5.Keep the workpiece (2) against the face of the miter gauge (3) and fl at against the table. Then slowly push the workpiece through the blade.
6.Do not try to pull the workpiece back with the blade turning. Turn the switch OFF, and carefully slide the workpiece out when the blade is completely stopped.
WARNING
Always position the larger surface of the workpiece
on the table when crosscutting and/or bevel
crosscutting to avoid instability.
WARNING
Always work to the right side of the blade during this type of cut. The miter gauge (1) must be in the right side groove (2) because the bevel angle may cause the blade guard to interfere with the cut if used on the left side groove.
1.Adjust the blade (3) to the desired angle, and tighten the blade bevel lock knob.
2.Tighten miter lock handle at 90°.
3.Hold workpiece fi rmly against the face of the miter gauge (1) throughout the cutting operation.
NOTE: When tilting the blade to 45°, the miter gauge handle will hit the blade guard.
Fig. EE | 3 2 | 1 |
– 19 –
