Fig. 11

NOTE

The guard bracket may come already mounted to the gear case on some models.

Install the blade guard on drive shaft tube against angle transmission. Tighten the guard bracket firmly so that the blade guard does not swing or move down during operation.

Install the blade guard to the guard bracket, which also secures the guard to the gear case using the two guard mounting screws.

CAUTION

Some blade guards are equipped with sharp line limiters. Be careful with handling it.

When using a trimmer head with two piece type blade guard, attach the guard extension to the blade guard. (Fig. 12)

Fig. 12

English

NOTE

○When attaching the guard extension to the blade guard, the sharp line limiter must be removed from the blade guard, (if so installed).

○If your unit has guard location label on drive shaft tube, follow the indication.

○To remove the guard extension, refer to the drawings. Wear gloves as the extension has a sharp line limiter, then push the four square tabs on the guard one by one in order. (Fig. 13)

Fig. 13

Installation of semi-auto cutting head

1.Function

Automatically feeds more nylon cutting line when it is tapped at low rpm (not greater than 4,500 rpm).

9