Hitachi CMP5000WXJ Audio Connections, Installation and Connections, Connecting the speakers

Models: CMP5000WXU CMP5000WXJ

1 40
Download 40 pages 6.04 Kb
Page 19
Image 19
Connection of composite SYNC analog RGB

Installation and Connections

Connection of composite SYNC analog RGB

source

Make composite SYNC connections for a personal computer with output that has the vertical synchronization signal layered on top of the horizontal synchronization signal.

When connecting to INPUT1

 

 

 

 

INPUT1

OUTPUT

 

ANALOG RGB

 

 

(ANALOG RGB)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Audio Connections

Before making connections, be sure to check that the audio component’s power and the unit’s main power is off.

Connecting the speakers

This unit is equipped with speaker output jacks for connection to the speaker system (not supplied) specially designed for use with this unit. Refer to the illustrations below when making connections to the speaker terminals on this unit.

Twist exposed wire strands together.

Push tab to the open position, and insert the wire. Then, close tab firmly to secure the wire in place.

English

On-screen setup is necessary after connection. Please see pages 14 and 15.

When connecting to INPUT2

(ON SYNC)

 

INPUT2

(H/V SYNC)

 

G

B

R

HD

VD

75Ô2.2k

When using INPUT2, set the impedance selector switch to match the output impedance of the connected computer’s synchronization signal.

When the output impedance of the computer’s synchronization signal is below 75 , set this switch to the 75 position.

On-screen setup is necessary after connection. Please see pages 14 and 15.

Notes

÷When making composite SYNC connections, do not connect anything to the VD jack. If connected, the picture may not be displayed properly.

÷On some types of Macintosh® components, G ON SYNC and composite SYNC are both output. With this type of component, please connect using the G ON SYNC connection (see page 10).

Note

When making speaker connections, be sure to match the polarities (+ and –) of the speaker terminals on this unit and the corresponding terminals on the speakers. If the polarity is reversed, the sound will be unnatural and lack bass.

Making connections to the audio inputs on this unit

This unit features two audio inputs and one audio output. The following chart shows the video inputs and the corresponding audio input jacks.

Video

Audio input jacks

Sound output

input

 

 

 

 

 

INPUT1

 

Sound of the selected video

Stereo mini jack

input is output from the

 

INPUT2

(L/R)

• SPEAKER terminals

 

• Stereo mini jacks (L/R).

 

 

 

 

 

Audio connections for component (computer) connected to INPUT 1 or INPUT 2

 

 

AUDIO

VD

 

INPUT OUTPUT

 

75Ô2k.2

(INPUT1/2)

 

 

Audio input to the AUDIO INPUT jacks (stereo mini jack) is possible for a

component connected to either INPUT1 or INPUT2. Sound is output from both the AUDIO OUTPUT jacks (stereo mini jack) and the SPEAKER terminals according to the video input selection.

Installation and Connections

11

En

Page 19
Image 19
Hitachi CMP5000WXJ Audio Connections, Installation and Connections, Connection of composite SYNC analog RGB source