Hitachi CMP5000WXJ Setting Up the System, Setup of CLAMP POSITION, 2Press 2/3 to select SET UP

Setting Up the System

CLAMP POSITION setup

Depending on the signal, analog RGB signals may result in the screen image appearing with a whitish or greenish cast. In such cases, set “CLAMP POSITION” to LOCKED.

÷Normally, leave this setting at AUTO.

Setup of CLAMP POSITION

1Press MENU to display the menu screen. The menu screen appears.

MAIN MENU						INPUT1
PICTURE	SCREEN			SET UP	OPTION
C O N T R A S T		:	0
BR I GHT .		:	0
R. L E V E L		: + 6 0
G. L E V E L		: + 6 0
B. L E V E L		: + 6 0
H. E NHAN CE		:	0
V . E NHAN CE		:	0
RE S E T
SELECT			SET	ENTER	MENU	EXIT

2Press 2/3 to select SET UP.

MAIN	MENU						INPUT1
PICTURE		SCREEN		SET UP		OPTION
	I N P UT L A B E L				: I N P UT 1
	POWE R		MA NAGEME NT : OF F
	C L AMP		P O S I T I O N		: A U T O
	S E T T I N G				: V G A
	SELECT		SET	ENTER	MENU		EXIT

4Press SET to select LOCKED.

MAIN	MENU					INPUT1
PICTURE		SCREEN		SET UP		OPTION
	I NP UT L A B E L				: I NP UT 1
	POWE R		MA NAGEME NT : OF F
	C L A MP P O S I T I O N				: L O C K E D
	S E T T I N G				: V G A
	SELECT		SET	CHANGE		MENU	EXIT

Mode selection will change as follows each time SET is pressed.

3AUTO LOCKED 2

5When the setup is completed, press MENU to exit the menu screen.

Notes

÷Make this CLAMP POSITION setting for each applicable input (INPUT1 and INPUT2).

÷When using this setup, be sure to carefully check the signal output of the component that you are using. For details, please refer to the instruction manual supplied with the component you are connecting.

English

Setting Up the System

3Press 5/∞ to select CLAMP POSITION.

MAIN	MENU						INPUT1
PICTURE		SCREEN		SET UP		OPTION
	I NP UT L A B E L				: I NP UT 1
	POWE R		MA NAGEME NT : OF F
	C L A MP P O S I T I O N				: A U T O
	S E T T I N G				: V G A
	SELECT		SET	CHANGE		MENU	EXIT

15

En