Hitachi 55PD5000, CMP5500, 55PMA550E, 37PD5000 Operating Instructions, Turning Power On and Off

22 24

OPERATING INSTRUCTIONS
	Turning Power On and Off
(37")	(55")
	• To turn the monitor power ON, press the main power
	switch on the monitor main unit to ON, and then press
	the SUB POWER button or the ON/OFF or ON button on
	the remote control.
Indicating lamp	• To turn the monitor power OFF, press the SUB POWER
	button or the ON/OFF or OFF button on the remote
Main power switch	control, and then press the main power switch on the
	monitor main unit to OFF.
	• During normal use, the main power switch is set in the ON
	position, and the monitor can then be turned ON/OFF using the
	SUB POWER button or the ON/OFF button on the remote control.
(37")
	Indicating lamp

ENGLISH

(55")

SUB-POWER button

Indicating	Power status	Operating
lamp
Off	Off	When the main power switch is set
		to OFF.
		When the main power switch is
	Off	ON, and the OFF button on the
Lights red		remote control or the SUB POWER
	(standby)
		button on the underside of the
		front of the frame is OFF.
		When the main power switch is
		ON, and the ON button on the
Lights green	On	remote control or the SUB POWER
		button on the underside of the
		front of the frame is ON.
		When the main power switch is
		ON, and the ON button on the
	Off	remote control or the SUB POWER
Lights orange		button on the underside of the
	(Power Save)
		front of the frame is ON.
		However, the state in POWER
		SAVE mode

POWER OFF
button
POWER ON	POWER ON/OFF
	button
button
	VOL
	RGB 1 RGB 2 MUTE VOL

AV1 AV2 AV3 AV4

AUTO PinP SIZE RECALL

MENU

When the indicating lamp lights in orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception. See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.”

ATTENTION

•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.

•Turn off the main power switch before leaving the monitor out of use for an extended period of time.

•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.

OK

ID ID SET

13