Hitachi CMP5500, 55PMA550E Operating Instructions Displaying Multi Picture, Pictures Split

(Sub- screen)

OPERATING INSTRUCTIONS (continued)

Displaying MULTI PICTURE

RECALL button

VOL

PinP button

RGB 1 RGB 2 MUTE VOL

RECALL button

AV1 AV2 AV3 AV4

AUTO PinP SIZE RECALL

If the PinP button on the remote control is pressed MULTI PICTURE will display.

Activating the P-in-P mode from the RGB input screen

Pressing the PinP button one time will display 2 pictures.

•This mode can be available from RGB1(DVI-PC) and RGB2(RGB) input.

•The speaker icon can be shifted up and down by pressing the and SELECT buttons; the audio of the video will be output from

the side on which the speaker icon	RGB2
is located.
	AV1
• The sub-screen position can be
selected up and down by pressing
SELECT buttons.

•The sub-screen can be selected with

the AV1, AV2, AV3, and AV4 buttons from the status that the speaker icon appears on the left side of AV✱ as shown in the diagram to the right.

•Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.

•"Frequency Mode" in the Setup Menu should be set to Movie when

sub-screen is the component signal of 1080i/50 or 1080i/60.

AV1: Displays the VIDEO input signal of the sub-screen.

MENU

OK

RETURN button

ID ID SET

2 Pictures (Split)

Activating the Split mode from the video input screen

Pressing the PinP button one	AV1	AV2
time will display 2 pictures.

•The speaker icon can be shifted left and right by pressing the and SELECT buttons; the audio of the video will be output from the side on which the speaker icon is located.

•The same video input mode cannot

be selected for both screens at the same time.

•Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.

•When the Video input is set to RGB Video, this Split mode is not possible.

•Refer to the table for 2 pictures (Split) mode.

Input terminal		AV1~AV4				AV1, AV2		RGB1	RGB2
	Sub	PAL	NTSC3.58	576i	480i	1080i/50 1080i/60	720p/60	STB	Component
	Main	SECAM	NTSC4.43	576p	480p					Sub
AV1	PAL, SECAM								Main
~AV4	NTSC3.58/4.43
	576i, 576p
AV1	480i, 480p
	1080i/50
AV2
	1080i/60
	720p/60
RGB1	STB
RGB2	Component
								(	: Available)
NOTE

•Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not change to power save mode.

•Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.

•The display will go out in approximately 6 seconds.

VIDEO

Off-timer On-timer

OFF -- -- Min.

-- -- : -- --

Input mode

AV1

Composite Signal mode

34