English
CAUTION:
◯Exercise care in preparing a pilot hole suitable for the wood screw taking the hardness of the wood into consideration. Should the hole be excessively small or shallow, requiring much power to drive the screw into it, the thread of the wood screw may sometimes be damaged.
6.Striking only (DH30PC)
This rotary hammer can be set to striking only mode by pressing the push button and turning the change
lever to 
mark. (Fig. 10)
(1)Mount the bull point or cold chisel.
(2)Press the push button and set the
change lever to 
mark or 
mark. Then rotation is released, turn the grip
and adjust the cold chisel to desired position. (Fig. 11)
(3)Turn the change lever to 
mark. (Fig. 10)
Then bull point or cold chisel is locked.
7. Using the stopper (Fig. 12)
(1)Loosen the side handle, and insert the stopper into the handle bolt hole.
(2)Adjust the stopper position according to the depth of the hole and tighten the side handle securely.
8.How to use the drill bit (taper shank) and the taper shank
adaptor.
(1)Mount the taper shank adaptor to the rotary hammer. (Fig. 13)
(2)Mount the drill bit (taper shank) to the taper shank adaptor. (Fig. 13)
(3)Turn the switch ON, and drill a hole in prescribed depth.
(4)To remove the drill bit (taper shank), insert the cotter into the slot of the taper shank adaptor and strike the head of the cotter with a manual hammer supporting on the rests. (Fig. 14)
Change Lever
Push Button
Fig. 10
Grip
Fig. 11
Handle Bolt
Knob on Side
Stopper Handle
Fig. 12
15
