Hitachi HDS723020BLA642 manual Off-Line Data Collection Status, Self-test execution status

7K200 SATA OEM Specification

223

Load Retry Count

Status Flag Definitions:

Bit	Flag Name	Definition
0	Pre-Failure/Advisory bit	If bit = 0, an Attribute Value less than or equal to its
		corresponding Attribute Threshold indicates an Advisory
		condition where the usage or age of the device has
		exceeded its intended design life period.
		If bit = 1, an Attribute Value less than or equal
		to its corresponding Attribute Threshold
		indicates a Pre-Failure condition where imminent
		loss of data is being predicted.
1	On-Line Collective bit	If bit = 0, the Attribute Value is updated only during
		Off-Line testing.
		If bit = 1, the Attribute Value is updated during On-Line
		testing or during both On-Line and Off-Line testing.
2-5	Reserved bits	may either 0 or 1
6-15	Reserved bits	Always 0

Table 113 Status Flag Definitions

Normalized Values: The device will perform conversion of the raw Attribute Values to transform them into normalized values, which the host can then compare with the Threshold values. A Threshold is the excursion limit for a normalized Attribute Value. In normalizing the raw data, the device will perform any necessary statistical validity checks to ensure that an instantaneous raw value is not improperly reflected in the normalized Attribute Value (i.e., one read error in the first 10 reads being interpreted as exceeding the read error rate threshold when the subsequent 1 billion reads all execute without error). The end points for the normalized values for all Attributes will be 1 (01h) at the low end, and 100 (64h) at the high end for the device. For Performance and Error Rate Attributes, values greater than 100 are also possible, up to a maximum value of 253 (FDh).

14.39.2.3Off-Line Data Collection Status

The value of this byte defines the current status of the off-line activities of the device. Bit 7 indicates Automatic Off-Line Data Collection Status.

Bit 7

0

1

Automatic Off-Line Data Collection Status

Automatic Off-Line Data Collection is disabled.

Automatic Off-Line Data Collection is enabled.

Bits 0 thru 6 represents a hexadecimal status value reported by the device.

Value Definition

0Off-line data collection never started

2All segments completed without errors. In this case, current segment pointer equals to total segments required.

4Off-line data collection suspended by interrupting command

5Off-line data collecting aborted by interrupting command

6Off-line data collection aborted with fatal error

14.39.2.4Self-test execution status

Bit	Definition
0-3	Percent Self-test remaining
	An approximation of the percent of the self-test routine remaining until completion in ten percent
	increments. Valid values are 0 through 9.
4-7	Current Self-test execution status
	0	The self-test routine completed without error or has never been run
	1	The self-test routine aborted by the host
	2	The self-test routine interrupted by the host with a hard or soft reset
	3	The device was unable to complete the self-test routine due to a fatal error or unknown test error

148/173