TROUBLESHOOTING
RECALIBRATING THE CONSOLE
To recalibrate the Console (21), first plug in the resist- ance system (see PLUGGING IN THE RESISTANCE
SYSTEM on page 20). Then, press and hold the NEXT button and the MOTORIZED WEIGHT
ADJUSTMENT + button for five seconds. When the buttons are released, a number will appear in the REPS display. Press the NEXT button again, and then press the MOTORIZED WEIGHT ADJUSTMENT
+button; this will start the recalibration process. This may take a few seconds as the motor moves between the lowest and highest resistance settings. When the
motor finishes, unplug the transformer from the !20- volt outlet.
The Console (21) will be recalibrated. Use the resist- ance system as described in the CONSOLE OPERA- TION section, starting on page 20.
TIGHTENING THE ROPE
The type of rope used on the resistance system can stretch slightly when it is first used. If there is slack in the rope before resistance is felt, the rope should be tightened.
To tighten the Rope (70), first set the system resist- ance level to 100 pounds. Locate the end of the Rope with the Rope Clamps (165, 166) and pull it out until the Rope is tight. Then, measure the distance between the Rope Cover (169) and the Swivel Arm (29).
Set the system resistance to the lowest level. Have a second peron pull the Rope (70) out and hold it while the Rope is adjusted. Push the Rope Cover (!69) down the Rope and loosen the two M5 x 16mm Button Screws (164). Pull the Rope through the Link (!67) and the Rope Clamps (165, 166) to shorten the Rope by the measured amount. Then, retighten the two Screws and cover the Rope Clamps with the Rope Cover. Note: There should be t/2" between the Link and the Rope Clamps.
29
70
Measure 169
Distance
164
169
70
167
166
22
