17.Press the Front Leg Foot (38) onto the Front Leg
(4). Note: The front of the Front Leg Foot is taller than the back of the Foot.
Attach the Front Leg (4) to the Rail (5) with four M8 x 20mm Screws (95) and four M8 Washers (152).
18.Pull out the Seat Knob (138) as far as it will go, and set the Seat Carriage (!6) on the Bench Rail
(5).
Loosely attach two 8mm Spacers (123), a 59mm Spacer (122), and two Seat Wheels (74) to the bottom holes in the Seat Carriage (16) with an
M8 Nylon Jamnut (139) and an M8 x 102mm Bolt (119). Make sure the parts are oriented as shown in the inset drawing.
19.Make sure that the wide sides of all six Seat Wheels (74) are pressed against the Rail (5). While a second person presses down on the Seat (25), hold the bottom Seat Wheels firmly against the bottom of the Rail and properly tighten the indicated M8 Nylon Jamnut (139).
Engage the Seat Knob (138) into an adjustment hole in the Rail (5).
17
95 95
152
Front is
taller _38
18 119
123
Side
123
19
74-
25
5-
74 74 139 138
12
