2.
3,
4.
Insert two M10 x 65mm Carriage Bolts (103) up through the Base (1). Place a piece of tape over the Bolt heads to hold them in place. Connect the Upright Base (2) to the Base with the two Carriage Bolts and two M10 Nylon Locknuts (!12). Do not tighten these Locknuts yet.
Connect the Upright Base (2) to the Base (1) with two M10 x 67mm Bolts (111) and two M10 Nylon Locknuts (112). Fully tighten these Locknuts.
Set the Mech Frame (!24) onto the Base (1) behind the Upright Base. Handtighten two M10 x
73mm Screws (137) and two M10 Washers (129) into the indicated holes in the Base and Mech
Frame, Note: The Mech Frame will not be
shown in the following drawings for clarity.
Note: One end of the Rope (70) is connected to the Right Arm Frame (17t). Untie the loose end of the Rope and route it through the Upright Base (2). Make sure the loose end of the Rope is still between the 90ram Thin Pulley (88) and
Cable Trap (78) (see the inset drawing), and that it crosses under the connected end of the
Rope.
Insert two M14 x 155mm Bolts (107) through the Right Arm Frame (171) and the Upright Base (2).
Hand tighten two M!4 Nylon Locknuts (!27) onto the Bolts,
Route the loose end of the Rope (70) through the Left Arm Frame (8) and a Swivel Arm (29). Make
sure the Rope is under the indicated rod in the Swivel Arm.
Attach the Swivel Arm (29) to the Left Arm Frame
(8) with an M4 x 5mm
Attach a
(29)with an M10 x 53mm Button Bolt (140) and an M10 Nylon Locknut (112),
Route the loose end of the Rope (70) through a Rope Cover (169) and a Link (167) as shown. Make sure the large hole in the Rope Cover is on the side shown. Secure the set of Rope Clamps (165, 166) on the Rope with two M5 x 16mm Button Screws (164), Make sure that Rope is in the grooves of the Rope Clamps, that there is t/2" between the Link and the Rope Clamps, and that the two Screws are fully tightened. Slide the Rope Cover over the Rope Clamps,
,1/07 | 2\/4.,_ | 4/ | _ | / |
_27
___137
129
78 88
93" | |
- |
4
164
70 169 _i
Hole | 166 | 67 |
7
