13.Attach the Upright Plate (23) to the Upright (3) with six M4 x 9mm
14.Attach the Console (21) to the Upper Wire Harness (172). The connector should slide easi- ly into the socket and snap into place. If a con- nector does not slide easily and snap into place, turn it over and then insert it. IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON- SOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Push the excess wire into the Upright (3).
Attach the Console (21) to the Upright (3) with two M4 x 80mm
15.Orient the Rail (5) with the holes on the side shown. Attach the Rail to the Upright Base (2) with an MIO x 106mm Bolt (19) and an MIO
Nylon Locknut (112). Do not overtighten the Loeknut; the Rail must be able to pivot easily.
Tighten the Storage Knob (44) into the Upright Base (2) and the Rail (5).
16.Orient the Seat (25) as shown. Attach the Seat to the Seat Carriage (!6) with four M6 x !6mm Screws (108).
13
14
15
Attach at
this hole
\
5
Holes
16
Wide
End
44
108
108
158
157
145
157
11
