ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•For help identifying small parts, use the PART IDENTIFICATION CHART. Note: Some small parts may have been
1,
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the resistance system, make sure all parts are oriented as shown in the draw-
ings.
E
The included hex keys W and the following tools (not included) are required for assembly:
•Two adjustable wrenches
•One rubber mallet
•One standard screwdriver
•One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, tape, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
Attach four Plastic Base Feet (71) to the Base (1) with four M4 Washers (157) and four M4 x 16mm
Attach a Wheel (49) to the Base (1) with an M8 x 90mm Shoulder Bolt (125), two M8 Washers
(152), and an M8 Nylon Jamnut (139). Repeat with the other Wheel.
152
1
\
_71
_ 157 | 104 |
104_'71
\
157
104
6
