20. Attach the Leg Lever (13) to the Front Leg | (4) | 20 |
with a Leg Lever Pin (91) and a Cotter Pin | (90). |
|
91
21.Route the short end of the Split Cable (72) through the Front Leg (4) and attach it inside the Leg Lever (13) with a Leg Lever Pin (91) and a Cotter Pin (90).
Attach a 90mm Pulley (92) inside the Front Leg (4), over the Spit Cable (72), with an M10 x 92mm Bolt (116), two M10 Washers (129), two 25mm Spacers (130), and an M10 Nylon Locknut (112).
22.Insert the two Short Pad Tubes (32) into the Leg Lever (13). Slide two Large Foam Pads (37) onto each Short Pad Tube.
Repeat this step with the Long Pad Tube (153) and the Front Leg (4).
21
72
91
112
129_ _ 130
22
4
37
13