Hitachi HV-D37A, HV-D27A operation manual 7GL MODE GL signal input changeover

7)GL MODE : GL signal input changeover

• VBS	: The VBS signal or BBS (black burst) signal is input as an external
	synchronizing signal.
• HD/VD	: The HD/VD signal is input as an external synchronizing signal.

Note: During external sync with HD and VD signals, be sure to use either RGB or Y, B-Y, R-Y output signals. Although VBS and Y/C output signals are also produced, these cannot be used as normal output signals.

8)SC.COARSE : Coarse adjustment of subcarrier phase

Using the L or R button, select one of the following phases; 0º, 90º, 180º and 270º.

9)SC.FINE : Fine adjustment of subcarrier phase

The allowable setting range is -128 to 127.

There is no direct relationship between a numeric value and a degree of phase. If the relevant range is exceeded, the SC COARSE setting is updated automatically to permit continuous adjustment.

10)H.PHASE : Adjustment of horizontal synchronization phase The allowable setting range is -128 to 127.

36