Hitachi L46S603 Quick Setup Guide, Antenna Connection, Power ON/OFF Your NEW Hitachi LCD TV

Quick Setup Guide

Perform the following steps to quickly setup your new Hitachi LCD Television Set.

1. ANTENNA CONNECTION

Unless your LCD Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

a). VHF (75-Ohm) antenna/CATV (Cable TV)

When using a 75-Ohm coaxial cable system, connect the CATV coaxial cable to theAIR/CABLE (75-Ohm) terminal. Or if you have an antenna, connect the coaxial cable to the same AIR/CABLE terminal.

Air/Cable

Rear Panel Jack

To outdoor Antenna	To Antenna
or
	Terminal
Cable TV (CATV)
System
b). VHF (300-Ohm) antenna/UHF antenna
When using a 300-Ohm twin lead from an outdoor antenna, connect
the VHF or UHF antenna leads to screws of the VHF or UHF adapter.
Plug the adapter into the antenna terminal on the TV.

To Antenna

Terminal To outdoor VHF or

UHF Antenna

Attach an optional antenna cable mixer to the TV antenna terminal and connect the cables to the antenna mixer. Consult your dealer or service store for the antenna mixer.

	Air/Cable
To UHF antenna	To outdoor antenna
	or CATV system

Antenna Mixer

c). When both VHF and UHF antennas are connected
NOTE	Connecting a 300-Ohm twin lead connector may cause interference. Using a 75-Ohm coaxial cable is recommended.
2. CONNECT YOUR NEW HITACHI LCD TV TO THE POWER SOURCE
a). Connect		the	power	cord	to your TV	set	and	c). The Indicating Lamp will light red (Standby mode) and
secure	it	with	the AC	Wire	Clamp (see	page	7) .	then light blue (image displays).

AC Wire Clamp

POWER

Indicating Lamp

b). Connect the power cord to the AC wall outlet .

3. POWER ON/OFF YOUR NEW HITACHI LCD TV.

Press the POWER button on the Remote Control or the POWER button on the Side Control Panel to power on/off the LCD TV.

or

For Stand-By

Power OFF

NOTE

If the Indicating lamp is OFF, the Power Button on the Remote Control will not operate. Please make sure that the power cord is plugged to the AC outlet.

4. FOLLOW THE TV SETUP WIZARD INSTRUCTIONS ON NEXT PAGE.

12