HMI settings, Setting up the display | Schneider Electric PM5300

Chapter 4—Front panel display and meter setup	PowerLogic™ PM5300 series user guide

HMI settings

Parameter	Values	Description

IP Address	Contact your local	The internet protocol address of your device.

		The Ethernet IP subnetwork address of your
Subnet	network administrator	The Ethernet IP subnetwork address of your
Subnet	network administrator	network (subnet mask).
	for parameter values.	network (subnet mask).
	for parameter values.
Gateway		The Ethernet IP gatway address of your network.

HTTP Server	Disabled	Controls whether your device’s webserver and
HTTP Server	Disabled	webpages are active or not.
		webpages are active or not.
Device Name	N/A	This parameter is read-only for reference purposes.

		This controls the network protocol for your device
		(what the meter uses to obtain its IP address).
		• DHCP: Dynamic Host Configuration Protocol
		• BOOTP: Bootstrap Protocol
		• Stored: Use the static value programmed in the
IP Method	DHCP, BOOTP,	IP Address setup register
IP Method	Stored, Default	• Default: Use 85.16 as the first two values of the
		IP address, then convert the last two
		hexadecimal values of the MAC address to
		decimal and use this as the last two values of
		the IP address.
		Example: MAC address = 00:80:67:82:B8:C8
		Default IP = 85.16.184.200

7. Press to exit. Press Yes to save your changes.

The HMI (human-machine interface) setup screens allow you to:

•control the general appearance and behavior of the display screens,

•change the regional settings, or

•change the meter passwords.

You can change the display screen’s contrast or the screen backlight and timeout settings.

1.Navigate to Maint > Setup.

2.Enter the setup password (default is “0000”), then press OK.

3.Navigate to HMI > Displ.

4.Move the cursor to point to the parameter you want to modify, then press Edit.

5.Modify the parameter as required, then press OK.

6.Move the cursor to point to the next parameter you want to modify, press Edit, make your changes, then press OK.

38	© 2014 Schneider Electric All Rights Reserved