Schneider Electric PM5300 manual Single resets, Single reset options, Alarm counter options

Chapter 13—Meter resets PowerLogic™ PM5300 series user guide

5. Press Yes to confirm the reset or No to cancel and return to the previous screen.

Single resets

Single resets allow you to clear data only in a specific register or register type.

1.Navigate to Maint > Reset.

2.Move the cursor to point to Single Reset, then press Select.

3.Move the cursor to point to the parameter you want to reset, then press Reset. If there are additional options for the parameter, press Select, move the cursor to point to the option you want, then press Reset.

Single reset options

Parameter		Option	Description
Energy	Accumulated		Clears all accumulated energy values (kWh,
			kVARh, kVAh).
			Select which demand registers to clear
Demand	Power, Current		(power demand, current demand or input
			metering demand).
	Event Queue		Clears the alarm event queue register.
	History Log		Clears the alarm history log.
Alarms		All Alarm Counts,	Select “Counters”, then select which counter
	Counters	(various alarm	to clear (choose all or individual alarm
		counters) — see the	counters listed in the “Alarm counter options”
		next table	table below).
		All Dig In Timers,	Select “Timers”, then select which status
	Timers	Status Input S1,	input timer to clear (choose all or individual
Status Inputs		Status Input S2	status input timers).
		All Dig In Counters,	Select “Timers”, then select which status
	Counters	Status Input S1,	input counter to clear (choose all or individual
		Status Input S2	status input counters).
		All Dig Out Timers,
	Timers	Digital Output D1,	Select “Timers”, then select which digital
		Digital Output D2,	output timer to clear (choose all or individual
		Relay R1,	digital output timers).
Digital Outputs		Relay R2
		All Dig Out Counters,
		Digital Output D1,	Select “Timers”, then select which digital
	Counters	Digital Output D2,	output counter to clear (choose all or
		Relay R1,	individual digital output counters).
		Relay R2
Active Load Timer			Clears and restarts the load operation timer.
Multi-Tariff			Clears accumulated values in all tariff
			register.

4.Enter the reset password if prompted (default is “0000”), then press OK.

5.Press Yes to confirm the reset or No to cancel and return to the previous screen.

Alarm counter options

Alarm counter	Option	Description
	Over Current, Ph
Current	Under Current, Ph	Select which alarm counter register to reset from
	Over Current, N	the current alarm condition counters.
	Over Current, Gnd
	Over Voltage, L-L
	Under Voltage, L-L
	Over Voltage, L-N	Select which alarm counter register to reset from
Voltage	Under Voltage, L-N
		the voltage alarm condition counters.
	Over Voltage Unbal
	Over Voltage THD
	Phase Loss

100 © 2014 Schneider Electric All Rights Reserved