Chapter | PowerLogic™ PM5300 series |
|
|
Locking or unlocking the meter
After you initialize the meter, you must lock it in order to conform to MID standards.
1.Navigate to Maint > Setup > Meter >Lock.
2.Press Edit to activate or deactivate the lock.
3.Enter your lock password.
NOTE: The default password is 0000. To set up a new password see “Setting up lock password” on page 112.
4.Press + and - to scroll between Active and Inactive.
5.Press OK to select the option.
6.Select Yes to confirm the selected option, and exit the screen.
On activating the lock, a lock icon appears on the upper left corner of the screen.
7.Make sure you record and store the lock password in a secure location. A lost lock password cannot be recovered.
Setting up lock password
To set up a new lock password, perform the below procedure. To change the password, make sure the lock is inactive and perform the below procedure.
NOTE: You cannot change the lock password when the lock is active.
NOTICE
IRRECOVERABLE PASSWORD
Record your meter's lock password information in a secure location.
Failure to follow this instruction can result in a permanently locked meter.
1.Navigate to Maint > Setup > HMI > Pass.
2. Press to scroll to Revenue Lock in the Passwords screen.
3.Press Edit to select a password.
4.Press + to increment the active digit through the numerals
5. Press | to move to the next digit to the left. |
6.Continue until all values are selected, and then press OK to set the password.
7.Press Yes to save the changes.
112 | © 2014 Schneider Electric All Rights Reserved |
