Schneider Electric PM5300 manual Configuring status inputs using the front panel

PowerLogic™ PM5300 series user guide Chapter 6—Input / Output

Configuring status inputs using the front panel

You can use the front panel to configure the status inputs.

Status input setup menu tree

Maint

Reset

Setup

Meter

Comm

Alarm

I/O

HMI

Clock

LED

SIn D Out Relay

1.Navigate to Maint > Setup.

2.Enter the setup password (default is “0”), then press OK.

3.Navigate to I/O > S In.

4.Move the cursor to point to the status input you want to set up, then press Edit.

5.Move the cursor to point to the parameter you want to modify, then press Edit.

NOTE: If Edit is not displayed, it means the parameter is either read-only or can only be modified through software.

6.Modify the parameter as required, then press OK.

Status input setup parameters available through the front panel

Parameter	Values	Description
Label	—	This can be modified only through software. Use this
		field to assign names to the status inputs (S1 and S2).
		Debounce is the time delay that compensates for
Debounce Time	0 to 1000	mechanical contact bounce. Use this field to set how
(ms)		long (in milliseconds) the external signal must remain in
		a certain state to be considered a valid state change.
		This field displays how the status input functions.
Control Mode	Normal	Normal: the status input is not associated with another
		meter function. The meter counts and records the
		number of incoming pulses normally.

7.Move the cursor to point to the next parameter you want to modify, press Edit, make your changes, then press OK.

8.Press to exit. Press Yes to save your changes.

Related topics

See “Technical Specifications” on page 15 for electrical characteristics and limits for the status inputs.

© 2014 Schneider Electric All Rights Reserved 51