PowerLogic™ PM5300 series user guide | Chapter |
Meter mounting
Mounting the PM5300
|
|
| 78.5 mm |
|
|
| 12.8 mm | 72.00mm |
|
96.00mm | 90 | .00° | 90.6mm | 107.4mm |
. | 90 | |||
00° |
| |||
|
| |||
| 96.00mm |
|
|
|
This section describes how to mount the meter.
The meter is designed to be mounted inside a
1.Inspect the gasket (installed around the perimeter of the front display) and make sure it is secured properly and not damaged.
2. Insert the meter through the mounting hole.
+0.8 | ||
- | 0.0 | |
92.0 | ||
mm | ||
| ||
8 | .mm |
. | 0 |
+0 | |
| 0 |
| . |
| 92 |
3.Line up the tabs of the retainer clips with the slots on either side of the meter. While holding the retainers at a slight angle, push the retainers in and forward to position them in place. In situations where the spacing between meters is tight, use a
screwdriver with a long, narrow shaft to help secure the clips.
18 | © 2014 Schneider Electric All Rights Reserved |
