English
INSTALLING THE MOTOR HOUSING
WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble.
1. Installing the motor housing | Motor |
| ||
Housing |
| |||
(1) | Open the lever. | Pin | Groove | |
(2) | While holding the base, insert the motor | |||
| ||||
| housing into the base aligning the pin with | Knob Nut |
| |
| the groove in the base. |
|
| |
(3) | Confirm that the pin and the groove are |
|
| |
| aligning. Rotate the motor housing |
| Lever | |
| clockwise into the base. | Base |
| |
(4) | Close the lock lever. |
| ||
CAUTION: | Fig. 4 |
|
You should be able to clamp the locking lever without excessive force. Excessive force may damage the base. You should not be able to move the motor in the base when the lever is clamped. To adjust the lever’s clamping force, open the locking lever and turn the knob nut in small increments. Turning the knob nut clockwise tightens the lever, while turning the knob nut counterclockwise loosens the lever.
HOW TO USE THE ROUTER
WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble.
1. Adjusting depth of cut
(1)Place the tool on a flat wood surface.
(2)Open the lever and turn the motor housing until the bit just touches the flat surface. (Fig. 5)
(3)Clamp the lever down until the point where a click can be felt. (Fig. 6)
NOTE:
The motor housing can be temporarily secured by clamping the lever (the motor housing does not slide down by its own weight).
If the motor housing slides down, make adjustments by tightening the knob nut. Turning the knob nut clockwise tightens the lever, while turning the knob nut counterclockwise loosens the lever.
Index Line
Motor
Housing 
Graduation
Scale Ring
BaseLever
Fig. 5
Knob Nut
Lever
Fig. 6
11
