Hitachi SJ2-CO instruction manual Parameter setting of the Inverter, Power Supply LED check

CHAPTER4 SETTING

4.2 Parameter setting of the Inverter

Following table describes setting items relate SJ200-2/L200-2 series Inverter with connecting SJ2-CO. Following parameter will appear with connecting SJ2-CO to SJ200-2/L200-2 Inverter.

Parameter	Function	Range of DATA	Initial	Note
			DATA
	Timer setting of
P044	Communication	0.00~99.99	0.00	**
	timeout Whilst
	running
	Inverter action	00(TRIP) / 01(TRIP after		It is effective when
	when	deceleration stop)
P045			01	“Object #6007”
	communication	/ 02(ignore) / 03(Free-RUN)
				setting is ‘-3’.
	error	/ 04(deceleration stop)
		0 to 38
	Motor Poles	(It is possible to set only even
		number )
	setting for
P049*		Setting value ‘0’, monitoring unit is	0
	revolution per
		Hz.
	minutes
		Setting value except ‘0’, monitoring
		unit is min-1.

Note*: As “P049 Command” value is setting ‘0’, unit of “Index 6042,6043,6044,6046,6048-1,6049-1” is ‘Hz’.

Note**: CANopen Interface Option cannot detect bus-off status with heartbeat. Using P045 command, set value of P044 instead of detecting bus-off status.

4.3 Power Supply LED check

If the Power Supply LED(See 1.3) is not ON ,please remount(See 2.1) the SJ2-CO unit again.

10