English
SPECIFICATIONS
Voltage (by areas)* | (110V, 115V, 120V, 127V, 220V, 230V, 240V) |
Power Input | 720W* |
Weight (without cord, side handle) | 4.2 kg |
|
|
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES |
|
(1) Case | 1 |
Standard accessories are subject to change without | |
notice. |
|
OPTIONAL ACCESSORIES (sold separately)
◯Demolishing
Bull point (Round type)
Bull point (Square type)
◯Groove digging and edging
Cold chisel
Cutter
◯Grooving
Grooving chisel
◯Hammer Grease A 500g (in a can)
70g (in a tube)
30g (in a tube)
Optional accessories are subject to change without notice.
APPLICATIONS
Demolishing concrete, chiseling concrete, grooving, bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility installation, machinery installation, water supply and drainage work, interior jobs, harbor facilities and other civil engineering work.
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
2.Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident.
3.Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
4.Installing Tools
CAUTION
To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle.
NOTE:
When using tools such as bull points, cutters, etc., make sure to use the genuine parts designated by
our company.
(1)Clean the shank portion of the tool.
(2)Insert the tool in a twisting manner into the tool holder until it latches itself. (Fig. 1, 2)
(3)Check the latching by pulling on the tool. (Fig. 3)
5.Deciding Working Position of Tool
The tool can be turned every 30 degrees and can be fixed at the position of 12 steps.
(1)As shown in Fig. 4, grip (B) is turned 60 degrees in the direction of A, the blade angle can be changed freely to any desired position. (Fig. 5)
(2)As shown in Fig. 6, return grip (B) in the direction of A, and make sure that it is locked completely.
6.Removing Tool
As shown in Fig. 7, pull front cap in the direction of A, and pull out the tool. (Fig. 8)
4
