LOADING NAILS
WARNING
⬤When loading nails into Nailer,
1)do not pull trigger;
2)do not depress push lever; and
3)keep Nailer pointed downward.
<NV83A2>
(1)Grip the nail guide and knob with finger.
Press the knob down and swing the nail guide open. And open the magazine cover.
English
(3)Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Nail holder
Nails
Magazine
(4)1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Knob
Nail guide
Magazine cover
Driving hole Guide slot First nail 2 3
Nail Guide
4
1
(2)Adjust the position of the plate according to the nail length.
The nail will not feed smoothly if the plate is not correctly adjusted.
Magazine
Magazine cover
Nail holder
NOTE: Before loading nails in the magazine, adjust the plate. If the magazine cover is forcibly closed without adjusting the plate correctly, the nail holder may be damaged.
1Turn the nail holder about 90 degrees
counterclockwise.
2Slide in vertical direction possible.
Lift or lower the nail holder to accept different length nails.
3Adjust the plate to the nail length reference points on the magazine cover and turn the nail holder 90 degrees clockwise until you hear "click".
2" |
|
21/4" 23/8" | 2 |
21/2" 23/4" |
|
3" 31/4" | 1 |
| 3 |
Magazine
Nail holder
Guide surface
2Feeder
4Pulling the nails to the right, swing the nail guide closed.
(5)Close the magazine cover first and swing the nail guide closed.
(6)Lock the knob correctly.
Knob
Magazine cover
Nail guide
NOTE: Be careful not to deform the collated wires and not to disengage the nails with the guide surface. Otherwise, the nail guide will not close correctly.
— 13 —
