English
MAINTENANCE
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled “SAFETY” (pages 4 – 7).
WARNING
⬤Disconnect air hose and remove all nails from Nailer when:
1)doing maintenance and inspection; and
2)clearing a jam.
1.Clearing a jam
Remove a jammed nail in the following order :
1DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet. Tap the rod with a hammer.
Hammer
Rod
Outlet
1
Disconnect air hose
4Remove the jammed nail with a slotted screw driver.
2. Inspecting the push lever
1DISCONNECT AIR HOSE.
2Clean the push lever sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
| 1 |
Lubricate | Disconnect |
air hose |
3. Inspecting the feeders
1DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Nail
Guide
|
| 1 | |
Push Lever | Knob | Disconnect | |
air hose | |||
|
Nail
Slotted Screw Driver
5Cut the deformed collated wire with nippers. Correct the deformation.
6In case of frequent jam, contact a Hitachi authorized service center.
3Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and shafts.
Nail Guide
Main Nail Stopper
Sub Nail Stopper | Nose Opening |
|
Feeder Shaft
Feeder
4 Lubricate the feeding surfaces of the nose and the nail guide after cleaning.
— 17 —
This promotes smooth operation and prevents rust.
