Installation, Operation and Care of

RO-150 Reverse Osmosis System

SAVE THESE INSTRUCTIONS

GENERAL

The Hobart RO-150 filter system is designed for foodservice equipment where high quality water is essential. The Hobart RO150 meets low water usage demands for steamers, combi-ovens, proofers, deck & rack ovens, and misting systems. Ensure that the water demand of the equipment does not exceed six gallons per hour or a total draw down of 13.5 gallons.

NOTE: The standard storage tank size is 20 gallon. Other sizes of storage tanks are available (up to 80 gallon).

NOTE: The RO-150 is intended only for water feeding the cooking equipment boiler or generator. A separate condensate line not treated by the RO-150 must be installed on equipment if required.

Filter cartridge replacement is recommended at least every 4 - 6 months for moderate to low usage and 90 days for high usage. The RO membrane should be replaced annually or when the removal of Total Dissolved Solids - TDS becomes less than 80% efficient (determined by comparison testing of water supply and product water).

UNPACKING

This water filter system was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage. If the water filter system is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

INCLUDED IN RO-150 FILTRATION SYSTEM

•Reverse osmosis filtration system assembly with supplied filters, cartridges and 24VAC transformer.

•20 Gallon storage tank (13 gallon capacity)*.

•3/8" Push on ball valve

•3/8" to 1/4" Push on tee

•1/4" Ball valve

•10' - 3/8" LLDPE John Guest tubing

•10' - 1/4" LLDPE John Guest tubing

•3/8" Plastic ferrules and stainless steel stiffening inserts

•Filter wrench

*The RO-150 filtration system can be purchased without a storage tank.

REQUIRED TOOLS

•Spirit Level

•PVC pipe cutter, razor blade tubing cutter or sharp razor knife

•Electric drill

•Marker

•Air pressure gauge capable of measuring 10-60 psi.

REQUIRED HARDWARE

•Connection fitting to water supply with 3/8" compression fitting

•Connection fitting to equipment with 3/8" compression fitting

•Teflon tape

•Two 3/16" diameter mounting screws at least 1- 1/4" in length.

•Appropriate wall anchor hardware for 3/16" screws

-3-