OPERATION
ADJUSTING IDLING SPEED
If the engine starts, runs, and accelerates but will not idle, turn the idling speed screw “ T ” clockwise to increase idling speed.
If the chain turns at idle, turn the idling speed screw “ T ” anticlockwise to reduce the idling RPM and stop the chain movement. If the saw chain still moves at idling speed, contact a Homelite service dealer for adjustment and discontinue use until the repair is made.
WARNING:
THE SAW CHAIN SHOULD NEVER TURN AT IDLE. Turn the idling speed screw “T” anticlockwise to reduce the idling RPM and stop the chain, or contact a Homelite service dealer for adjustment and discontinue use until the repair is made.
Serious personal injury may result from the saw chain turning at idle.
Fig. 26
WARNING:
Weather conditions and altitude may affect carburation.
Do not allow bystanders close to the chainsaw while adjusting the carburettor.
OPERATING THE CHAIN BRAKE
Refer to “Safety” earlier in this manual for additional information.
Check the operating condition of the chain brake before each use.
1.Start the engine and grasp the front and rear handles securely with both hands.
2.Pull the throttle trigger to bring the chainsaw up to full speed. Using the back of your left hand, engage the chain brake by pushing the chain brake lever/hand guard towards the bar while the chain is rotating rapidly. See Figure 27.
NOTE: The chain brake should engage and stop the chain immediately. If not, stop the saw by pressing the “ / O ” on ignition switch. Take the saw to a Homelite service dealer for repair and discontinue use until the repair is made.
3.Reset the chain brake back into the RUN position by grasping the
BRAKE POSITION
Fig. 27
RUN POSITION
Fig. 28
WARNING:
If the chain brake does not stop the chain immediately, take the saw to a Homelite service dealer for repair before use.
UK - Page 19
