BAR AND CHAIN COMBINATIONS
Recommended Bar and chain combinations
For 0.325 Low Profile 0.050 Gauge
| Length of Bar | Guide Bar Part Number | Chain Part Number |
| 406 mm (16 in.) | PS06132 | PS06136 |
| 457 mm (18 in.) | PS06131 | PS06135 |
| 508 mm (20 in.) | PS06107 | PS06134 |
|
|
| |
|
| TROUBLESHOOTING | |
|
|
|
|
|
|
|
|
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
Engine will not start. | 1. No spark. |
Make sure ignition |
|
switch is in start |
|
position (“I”). |
|
| 2. Flooded engine. |
1.Check spark. Remove air filter cover. Remove sparking plug from cylinder. Reattach the sparking plug wire and place sparking plug on top of cylinder with the metal part of plug touching the cylinder. Pull the starter rope and watch for spark at sparking plug tip. If there is no spark, repeat test with a new sparking plug.
2.With the ignition switch off, remove sparking plug. Move choke lever to run position (pushed in completely) and pull starter cord 15 to 20 times. This will clear excess fuel from engine. Clean and reinstall sparking plug. Set ignition switch to run (I) position. Push and fully release primer bulb 7 times. Pull starter three times with choke lever at run. If engine does not start, move choke lever to choke and repeat normal starting procedure. If engine still fails to start, repeat procedure with a new sparking plug.
Engine starts but will not | Carburettor requires “L” (Low jet) | Contact a Homelite service dealer for carburettor | ||
accelerate properly. | adjustment. | adjustment. | ||
|
|
| ||
Engine starts but will not | Carburettor requires “H” (High jet) | Contact a Homelite service dealer for carburettor | ||
run properly at high | adjustment. | adjustment. | ||
speed . |
|
|
|
|
|
|
|
|
|
Engine does not reach | 1. | Check oil fuel mixture. | 1. | Use fresh fuel and the correct |
full speed and/or emits | 2. | Air filter dirty. | 2. | Clean air filter. Refer to “Maintenance – Cleaning the |
excessive smoke. |
|
|
| Air Filter” earlier in this manual. |
| 3. | Spark arrester screen dirty. | 3. | Clean spark arrester screen. Refer to “Maintenance |
|
|
|
| – Cleaning the Spark Arresting Silencer” earlier in |
|
|
|
| this manual. |
| 4. | Carburettor requires “H” (High | 4. | Contact a Homelite service dealer for carburettor |
|
| jet) adjustment. |
| adjustment. |
|
|
|
|
|
UK - Page 37
