Homelite HL80833 manuel dutilisation Trigger Handle

ASSEMBLY

connecting high pressure hose to

TRIGGER HANDLE

See Figure 7.

nScrew the collar on the high pressure hose into the trigger handle inlet coupler by turning the hose collar clockwise.

nPull on the hose to be certain it is properly secured.

connecting the high pressure hose to the pump

See Figure 8.

nAlign the collar on the threaded nipple on the pump.

nInsert the nozzle on the end of the high pressure hose collar into the threaded nipple.

nTurn the collar clockwise to tighten the hose securely to the pump.

nPull on the hose to be certain it is properly secured.

attaching INJECTION hose

See Figure 9.

Before detergent can be used with this machine, the injection hose must be attached.

nOpen the cap of your detergent container.

nPush the injection hose filter onto the end of the injec- tion hose. Insert the injection hose into your detergent container so the injection hose filter rests at the bottom of the detergent container.

nPush the open end of the injection hose securely over the fitting as shown in figure 9.

connecting the garden hose to the pressure washer

See Figures 10 - 11.

CAUTION:

Always observe all local regulations when connnecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water sup- ply to prevent the feedback of chemicals into the drinking water supply. Direct connection through a receiver tank or backflow preventer is usually permitted.

The water supply must come from a water main. NEVER use hot water or water from pools, lakes, etc. For ease of use, a self-coiling garden hose is provided.

Note: When using the self-coiling garden hose, be sure that the hose does not become crimped during use as this may cause damage to the pump.

Before connecting the garden hose to the pressure washer:

nRun water through the hose for 30 seconds to clean any debris from the hose.

nInspect the screen in the water intake.

nIf the screen is damaged, do not use the machine until the screen has been replaced.

nIf the screen is dirty, clean it before connecting the garden hose to the machine.

To connect the garden hose to the machine:

nIf using a garden hose that is not self-coiling, straighten the garden hose.

Note: There must be a minimum of 10 feet of unrestricted hose between the pressure washer intake and the hose faucet or shut off valve (such as a “Y” shut off connec- tor).

nWith the hose faucet turned completely off, attach the end of the garden hose to the water intake. Tighten by hand.

nWrap the garden hose hanger strap around the garden hose to keep it close to the handle and out of the way.

installing surface cleaner

See Figures 12 - 14.

To install the surface cleaner on the pressure washer:

nConnect the lower end of the high pressure water supply hose to the surface cleaner by inserting the deck inlet plug into the quick connect coupler on the water supply hose. Push ends together until coupler snaps into position.

nSlide surface cleaner and pressure washer housing together until the connection is secure.

nInsert upper end of high pressure water supply hose into trigger handle outlet coupler and push ends together until coupler snaps into position.

To install the surface cleaner on the spray wand:

nAssemble the trigger handle and spray wand as described previously in this manual.

nInsert surface cleaner inlet plug into the spray wand quick connect coupler and push ends together until coupler snaps into position.

WARNING:

To reduce the risk of injection injury, only use the surface cleaner on flat, horizontal surfaces. Never lift the surface cleaner from the cleaning surface while operating the pressure washer.

9 — English