Homelite UT10519, UT10526 General Maintenance, Lubrication, Replacing the guide BAR and Chain

maintenance

WARNING:

When servicing, use only identical Homelite replacement parts. Use of any other parts may create a hazard or cause product damage.

Run

Position

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing and head protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, lubricant, grease, etc.

WARNING:

Fig. 34

Fig. 35

Do not at any time let brake fluids, gas- oline, petroleum-based products, pene- trating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

LUBRICATION
All of the bearings in this product are lubricated with		clutch
a sufficient amount of high grade lubricant for the
	sprocket	cover
life of the unit under normal operating conditions.
Therefore, no further lubrication is required.		Fig. 36

REPLACING THE guide BAR AND CHAIN

See Figures 34 - 43.

DANGER:

Never start the engine before installing the guide bar, chain, clutch cover, and clutch drum. Without all these parts in place, the clutch can fly off or explode, exposing the user to possible serious injury.

WARNING:

To avoid serious personal injury, read and understand all the safety instructions in this section.

nAlways place the switch in the stop “ O ” posi- tion before you work on the saw.

Page 25 — English