SECTION 6: MAINTENANCE
Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.
Schedule
For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.
Daily Check:
•Loose mounting bolts.
•Damaged saw blade.
•Worn or damaged wires.
•Any other unsafe condition.
•Clean and wipe down after each use.
•Proper blade tension.
•Check cutting fluid level.
Monthly Check:
•Lubricate vise screw.
•Check cutting fluid level.
Annual Check:
•Replace cutting fluid and clean out tank. If the saw is used heavily, clean the tank and replace the cutting fluid at a sooner inter- vals.
Cleaning
Cleaning the Model G0613/14 is relatively easy. After using your bandsaw, vacuum up excess chips or by sweeping them up.
If using water based cutting fluid, wipe down and lubricate areas where the liquid may collect, causing rust after a period of time.
G0613/14 Swivel Mast Metal Cutting Bandsaw
Lubrication
1. Before applying lubricant to any area, wipe the area clean to avoid contamination. Lubricate the blade tensioner leadscrew (Figure 31) with general purpose grease, and apply a coat of general purpose oil to all unprotected cast iron surfaces.
Note: All bearings and the gearbox on the Model G0613/14 are lubricated and sealed for life. No further attention is needed unless damage occurs.
Blade Tensioner Lead Screw
