Recommended

 

Test Run

Adjustments

 

 

 

 

 

 

 

 

 

 

 

 

The adjustments listed below have been per- formed at the factory. However, because of the many variables involved with shipping, we recom- mend that you verify the following adjustments before the Test Run and to ensure cutting results meet your standards.

Step-by-step instructions on verifying these adjust- ments can be found in SECTION 7: SERVICE

ADJUSTMENTS.

Factory adjustments that should be verified:

1.Blade Tension (Page 33).

2.G0613 Blade Guide Adjustment (Page 34).

3.G0614 Blade Guide Adjustment (Page 36).

4.Stop Adjustments (Page 38).

5.Blade Squaring Adjustment (Page 40).

G0613/14 Swivel Mast Metal Cutting Bandsaw

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

Starting the machine:

1.Read the entire instruction manual.

2.Make sure all tools and foreign objects have been removed from the machine.

3.Make sure that you verify the Recommended Adjustments listed on this page.

4.Fill the cutting fluid reservoir with cutting fluid if not done so already, DO NOT run the pump without cutting fluid or you will damage the pump.

5.Put on safety glasses and secure loose clothing or long hair.

6.Connect the bandsaw to power.

7.Raise the bandsaw and close the feed rate control knob to keep the saw in place.

8.Start the bandsaw while keeping your finger near the EMERGENCY STOP/OFF button at all times during the test run. The bandsaw should run smoothly with little or no vibra- tion.

Note: If the EMERGENCY STOP/OFF but- ton is pressed, it needs to be twisted until it pops out or the bandsaw will not start.

—If you hear or see any problems, immedi- ately stop the bandsaw and correct before continuing.

—If you need any help with your bandsaw call our Tech Support at (570) 546-9663.

-19-

Page 21
Image 21
Grizzly G0614, G0613 owner manual Recommended Test Run, Factory adjustments that should be verified