8.Double check bearing adjustments.
9.Adjust the other blade guide, and reinstall the blade guide guards and the limit switch.
10.Adjust the auto stop bolt and the bow stop bolt (Figure 42), so the bandsaw motor will stop when the blade teeth are just below the vise table surface.
11.Go to Setting Stops on Page 38 and com- plete the steps to make sure the cuts will be perpendicular to the table.
Limit Switch and
Auto Stop Bolt
Bow
Stop
Bolt
Figure 42. Auto stop and bow stop bolts.
G0613/14 Swivel Mast Metal Cutting Bandsaw |
