G0613/14 Swivel Mast Metal Cutting Bandsaw -23-
Blade Selection
The Model G0613 uses a 34" wide x 82" long x
0.35" thick bandsaw blade.
The Model G 0614 uses a 1" wide x 9758" long x
0.35" thick bandsaw blade.
Do some research for your specific situation so
you get the best blade to match your needs.
Selecting the right blade for the job depends on
a variety of factors, such as the type of mate-
rial being cut, hardness of the material, material
shape, machine capability, and operator tech-
nique.
Grizzly offers a variety of selections that can be
found in the current catalog and in SECTION 5:
ACCESSORIES on Page 27.
The chart shown in Figure 18 is a reproduction of
the chart on the blade cover of your bandsaw. Use
it as a rough guideline.
������
�����
�������
����������
�������
���������
�������
���������� ���
����
�������
����������
���
����
�������
����������
���
����
���������
��������� ������
���������
�������
���������
�����
���������
�������
���������
������
���������
�������
���������
�������
���������
�������
����������
���
����
�������
����������
�������
���������
��������
�����
����
����
�����
�����
������
�����
���������
������
���������
������
���������
������
���������
������
��������
���������������
���������������������������������
�������� �������� ��������
����������
����������
����������
����������
�����
�����
�����
���������
����������
���������
����������
����������
����������
��������������
���������������
����
���������
�������
����������
���������
���������
���������
��������
���������
����������
��������
����������
�������������
����������
��
� � � � � �� �� �� �� �� �� �� �� �� ����
�� ��� ��� ��� ��� ��� ��� ���
���
���
��� �������
�������
�����
�����
���
���
���
���
���
���
���
��
����
Blade Speed
The Model G0613 is a single speed (314 FPM)
bandsaw. Like the G0614, it has a cutting fluid
system which gives the saw a wider cutting range
than a single speed bandsaw that is not equipped
with a cutting fluid system.
The Model G0614 has a two speed control rang-
ing from 170 to 341 feet per minute (FPM). The
speed is controlled by a rotary switch and can be
switched while the motor is operating.
Material Width/Diameter
Material Shapes Teeth Per Inch (TPI)
Figure 18. G0613/14 general blade selection and speed chart.
NOTICE
On the Model G0614, DO NOT change motor
speed during a cut as this may overload a
series of engaged blade teeth.