MAINTENANCE
nRefill the oil tank with fresh hydraulic oil (3.7 quarts or 118 oz.).
nPlace the cleaned dipstick into the oil tank. Remove and check the oil level.
NOTE: The oil level should be between the two grooves around the bottom of the dipstick as shown in figure 5.
nReplace oil drain bolt. Tighten securely.
nDispose old oil at an oil recycling center.
SHARPENING THE WEDGE
After using the log splitter for some time, it may be necessary to sharpen the wedge. Using a
to lock the log splitter
See Figure 15.
To prevent unauthorized use of the log splitter when moving, storing, or leaving the machine unattended, disconnect it from the power supply and install a padlock (not included) through the hole in the hydraulic control lever.
TROUBLESHOOTING
Problem |
| Possible Cause |
| Solution |
Motor fails to start | 1. | Overload Protection Device is | 1. | Push reset button. See Figure 14. |
|
| disengaged to protect the log |
|
|
|
| splitter from being damaged. |
|
|
|
|
|
|
|
Won’t split logs | 1. | Log is improperly positioned. | 1. | Refer to Operation section for log |
|
|
|
| loading. |
| 2. | The size or hardness of the log | 2. | Reduce the log size before splitting. |
|
| exceeds the machine’s capacity. |
|
|
| 3. | Wedge cutting edge is blunt. | 3. | Refer to “Sharpening Wedge” in the |
|
|
|
| Maintenance section. |
| 4. | Oil leaks. | 4. | Locate leak(s). Contact the dealer. |
| 5. | Unauthorized adjustment was | 5. | Contact the dealer. |
|
| made on the Maximum Pressure |
|
|
|
| Limiting Screw. Lower maximum |
|
|
|
| pressure rating was set. |
|
|
|
|
|
| |
Log mover jerks and vibrates | 1. Lack of hydraulic oil and | 1. | Check oil level for possible oil | |
|
| excessive air in the hydraulic |
| refilling. Contact the dealer. |
|
| system. |
|
|
|
|
|
| |
Oil leaks around cylinder ram or | 1. Air sealed in hydraulic system | 1. | Loosen bleed screw by | |
from other points |
| while operating. |
| before operating the log splitter. |
| 2. | Bleed screw is not tightened | 2. | Tighten the bleed screw before |
|
| before moving the log splitter. |
| moving the log splitter. |
| 3. | Oil drain bolt is not tight. | 3. | Tighten the oil drain bolt. |
| 4. | Hydraulic control valve assembly | 4. | Contact the dealer. |
|
| and/or seal(s) are worn. |
|
|
|
|
|
|
|
11 — English