ASSEMBLY
attaching INJECTION hose
See Figure 4.
Before detergent can be used with this machine, the injection hose must be attached.
nPush the open end of the clear injection hose securely over the fitting as shown.
NOTE: Keep injection hose away from hot surfaces.
nPlace the filtered end of the injection hose in the bottle of detergent.
assembling the spray wand TO THE TRIGGER HANDLE
See Figure 5.
To attach the spray wand:
nPlace the threaded end of the spray wand in the connec- tor on the end of the trigger handle.
nTurn the connector clockwise until it stops. This secures the spray wand in place.
nWhen not in use, remove the spray wand from the trigger handle by turning the connector counterclockwise. When not in use, store each piece in the storage area on the sides of the pressure washer frame.
connecting high pressure hose to TRIGGER HANDLE Assembly
See Figure 6.
nScrew the collar on the high pressure hose into the trigger handle’s inlet coupler by turning the hose collar clockwise.
nPull on the hose to be certain it is properly secured.
connecting the high pressure hose to the pump
See Figure 7.
connecting the garden hose to the pressure washer
See Figure 8.
CAUTIOn:
Always observe all local regulations when connnecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water sup- ply to prevent the feedback of chemicals into the drinking water supply. Direct connection through a receiver tank or backflow preventer is usually permitted.
The water supply must come from a water main. NEVER use hot water or water from pools, lakes, etc. Before connecting the garden hose to the pressure washer:
nRun water through the hose for 30 seconds to clean any debris from the hose.
nInspect the screen in the water intake.
nIf the screen is damaged, do not use the machine until the screen has been replaced.
nIf the screen is dirty, clean it before connecting the garden hose to the machine.
To connect the garden hose to the machine:
nUncoil the garden hose.
NOTE: There must be a minimum of 10 feet of unrestricted hose between the pressure washer intake and the hose faucet or shut off valve (such as a “Y” shut off connector).
nWith the hose faucet turned completely off, attach the end of the garden hose to the water intake. Tighten by hand.
After the high pressure hose has been uncoiled and attached to the spray wand:
nAlign the collar on the threaded nipple on the pump.
nInsert the nozzle on the end of the high pressure hose collar into the threaded nipple.
nTurn the collar clockwise to tighten the hose securely to the pump.
nPull on the hose to be certain it is properly secured.
CAUTIOn:
Do not run the pressure washer pump without water sup- ply connected and turned on, as this may damage the high pressure seals and decrease pump life. Completely unwind the hose from its reel or coil and make sure the hose is not being restricted by tires, rocks, or any other objects that may lessen or prevent water flow to the pressure washer.
Page 9 — English
