Connecting a Computer for Controlling the Projector
Connect a computer for controlling the projector to the projector via the ETHERNET connector or the RS232C connector.
Connecting the Computer via the Ethernet
Connect the computer to the projector using the supplied ethernet cable (cross cable).
Note
Set the TCP/IP protocol of the connected computer to DHCP.
| R(Pr/Cr) | G(Y/Y) | B(Pb/Cb) | HD | VD |
| R(Pr/Cr) | G(Y/Y) | B(Pb/Cb) | HD | VD |
| IN | OUT |
|
| |
INTER LOCK ETHERNET RS232C | IN | OUT |
|
| |
ETHERNET connector
Ethernet cable (cross cable) (supplied)
Computer
Ethernet connector
CAUTION
For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port.
ATTENTION
Par mesure de sécurité, ne branchez pas le connecteur d’un périphérique ayant une tension excessive à ce port. Suivez les instructions pour ce port.
VORSICHT
Schließen Sie das Kabel aus Sicherheitsgründen nicht an |
| |
eine Buchse für Peripheriegeräteanschluss an, die eine zu |
| |
| ||
| ||
| ||
hohe Spannung aufweisen könnte. Befolgen Sie die |
| |
| ||
| ||
| ||
| ||
Anweisungen für diesen Anschluss. | Chapter 2 | |
| ||
Note |
| |
If the power of the projector remains on for a long period | Preparations | |
| ||
of time without the Ethernet cable connected, the message |
| |
“Sony SR Projector Initializing…” may appear in the |
| |
STATUS MESSAGE window while you are setting up for |
| |
networking after connecting the Ethernet cable. This is not |
| |
a malfunction of the projector. |
| |
Connecting the Computer via the RS-232C
| R(Pr/Cr) | G(Y/Y) | B(Pb/Cb) | HD | VD |
| R(Pr/Cr) | G(Y/Y) | B(Pb/Cb) | HD | VD |
| IN | OUT |
|
| |
INTER LOCK ETHERNET RS232C | IN | OUT |
|
| |
RS232C connector
Connecting cable (not supplied)
Computer
Connecting a Computer for Controlling the Projector
