Chapter 1 Overview
aMenu bar
File menu
Selecting “Quit” from the File menu exits the SRX Controller.
Back menu
Click to return to the Browser Screen window of the SRX Controller.
Password menu
Use to set the authentication passwords required for displaying the SETTING window and the SERVICE window. The Password menu can be displayed only when an authorized administrator starts the SRX Controller on the computer for controlling the projector.
For details on the SETTING window and the SERVICE window, refer to the Installation Manual for Dealers.
Help menu
Shows the version and serial number of the SRX Controller.
bSCREEN CONTROL window
For details, see “SCREEN CONTROL window” on page 10.
cInformation window
message is displayed in the STATUS MESSAGE window on the left side of the projector.
dPOWER ON/STANDBY (?/1) buttons and
POWER indicator
Click ON to turn on the lamp. The indicator lights green. Clicking STANDBY opens the confirmation dialog. Clicking “OK” makes the projector enter standby mode. The indicator flashes green. Even in standby mode, the fans continue to run to reduce internal heat. When the fans stop running, the indicator lights red.
eFUNCTION 1/2/3 radio buttons
Register the data set or adjusted with “Signal Adjust” in the PICTURE CONTROL window and “Color” in the COLOR/FRAME window. You can recall it later to project the image with that setting.
For details, see “To register the settings that have been adjusted” on page 25.
fWindow select buttons
Open the window with the items you want to set or adjust.
gAdjustment/setting window
Clicking the window select button switches the window for the adjustment and setting.
The “PICTURE CONTROL,” “COLOR/FRAME” and “INSTALLATION” windows can be displayed.
For details on each window, see “Adjustments and Settings Using the SRX Controller” on page 25.
SCREEN CONTROL window
1 | 2 | 3 | 4 | 5 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Location: Shows the location where the projector is installed, as set in the SETTING window at the time of installation.
Name: Shows the name of the projector that was set in the SETTING window at the time of installation.
Operation Timer: Shows the operation hours of the projector.
Lamp A/Lamp B: Shows an approximate percentage to indicate the time used before the recommended time for replacement of each projection lamp (i.e. 100% indicates the time for replacement). The indicator on the left lights when the corresponding lamp turns on. It does not light when the corresponding lamp turns off.
Warning Info: Displays an error message if there is any warning information on the projector. The same
aScreen mode buttons
Select
display mode. Click 
for single, 
for dual and 
for quad mode.
bCUT OFF “ON/OFF” buttons
Click the ON button to cut off the picture momentarily. Click the OFF button to restore the picture.
The SCREEN CONTROL window changes depending on the screen mode selected with the screen mode button (1). When dual- or
GB 10
Location and Function of Controls
