ASSEMBLY
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose Trigger Handle
Spray Wand
Injection Hose Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this tool until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
INSTALLING THE HANDLE
See Figure 2.
nPush and hold the button on the handle as you slide the handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock button snaps through the locking slot to secure the handle in place.
ASSEMBLING THE TRIGGER HANDLE
See Figure 3.
nPlace the threaded end of the spray wand in the connec- tor on the end of the trigger handle.
nTurn the connector clockwise until it stops. This secures the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE
See Figure 4.
nScrew the collar on the high pressure hose into the trigger handle inlet coupler by turning the hose collar clockwise.
nPull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO THE PUMP
See Figure 5.
Afterthe high pressure hose has been uncoiled and attached to the spray wand:
nAlign the collar on the threaded nipple on the pump.
nInsert the the end of the high pressure hose collar into the threaded nipple.
nTurn the collar clockwise to tighten the hose securely to the pump.
nPull on the hose to be certain it is properly secured.
CAUTION:
Do not run the pressure washer pump without water sup- ply connected and turned on, as this may damage the high pressure seals and decrease pump life. Completely unwind the hose from its reel or coil and make sure the hose is not being restricted by tires, rocks, or any other objects that may lessen or prevent water flow to the pressure washer.
CONNECTING THE GARDEN HOSE TO THE PRESSURE WASHER
See Figure 6.
CAUTION:
Always observe all local regulations when connnecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water sup- ply to prevent the feedback of chemicals into the drinking water supply. Direct connection through a receiver tank or backflow preventer is usually permitted.
