FEATURES
PRODUCT SPECIFICATIONS
ENGINE |
|
|
Engine Type | 4 Stroke, OHC (Chain Drive) | |
Bore x Stroke | 67 mm x 60 mm | |
Cooling System | Forced Air | |
Compression Ratio | 8:5:1 | |
Starting System | Recoil | |
Ignition System | T.C.I. | |
Spark Plug | NGK | |
Engine Lubricant Volume | 20 oz. | |
Fuel Volume | 4 gal. | |
*Rated running watts determined by PGMA Standard G200
GENERATOR |
|
Rated Voltage | 120V/240V |
Rated Amps | 30.4 A/15.2 A |
Rated Running Watts* | 3,650 W |
Rated Starting Watts | 4,550 W |
Rated Frequency | 60 Hz |
DIMENSIONS |
|
Length | |
Width | |
Height | 24 in. |
Weight | 159 lbs. |
KNOW YOUR GENERATOR
See Figure 2.
The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator against electrical overload.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
CORD RETAINERS
Use the cord retainers to prevent plugs from being acciden- tally pulled out of the 120 volt receptacles.
ENGINE SWITCH
The engine switch is used in combination with the recoil starter grip to start the generator. It is also used to turn the generator off.
FUEL TANK
The fuel tank has a capacity of 4 gallons.
FUEL VALVE
The flow of fuel through the generator is controlled by the position of the fuel valve.
GROUND TERMINAL
The ground terminal is used to assist in properly ground- ing the generator to help protect against electrical shock. Consult with a local electrician for grounding requirements in your area.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the generator when necessary.
OIL DRAINAGE BOLT
When changing the engine lubricant, the oil drainage bolt is loosened to allow old engine lubricant to be drained.
RECEPTACLES
Your generator has the following single phase, 60 Hz outlets: four 120 Volt AC, 20 Amp GCFI receptacles, and one 240 Volt AC, 20 Amp receptacle. These can be used for operat- ing appropriate appliances, electrical lighting, tools, and motor loads.
RECOIL STARTER GRIP
The recoil starter grip is used (along with the engine switch) to start the generator’s engine.
Page 10 — English
