Honeywell 1200g Sequence Timeout, Output Sequence Editor

SEQBLKsequence editor start command

62 code identifier for Code 39

0012 A - Code 39 sample length (11) plus CR suffix (1) = 12

41start character match for Code 39, 41h = “A”

FF termination string for first code

6A code identifier for Code 128

0013 B - Code 128 sample length (12) plus CR suffix (1) = 13

42start character match for Code 128, 42h = “B”

FF termination string for second code

69code identifier for Code 93

0012 C - Code 93 sample length (11) plus CR suffix (1) = 12

43start character match for Code 93, 43h = “C”

FF termination string for third code

Output Sequence Editor

Enter Sequence

Default Sequence

Sequence Timeout

You may wish to set the maximum time between bar code scans in an output sequence. If that maximum time is not met, the output sequence operation is terminated. Set the length (in milliseconds) for a timeout by scanning the bar code below, then setting the timeout (from 1-65535 milli- seconds) by scanning digits from the Programming Chart, then scanning Save. Default = 5000 msec.

Sequence Timeout

3 - 19